Slayer STEAM SINGLE - Coffee Brewing

8
EN
OFF 12:34a
Mon
• Turn the Encoder knob to activate the heating element
DQG VWDUW WKH KHDWLQJ SKDVH7KH %DULVWD'DVKERDUG
shows the main screen:
Time Temp Stm M
12.3s 00.2°C 0.0b
NOTE. During the heating phase, moving the
group actuator from the right position to the
center or left position will dispense water at the
temperature reached at that time.
Fig. 5.3 - Group actuator positions
Hot water and steam cannot be dispensed
at this stage. Using the respective actua-
tors will display the following message:
Machine Cold
Machine Cold
Brewings will be available only when the pro-
grammed working pressure is reached.
• While waiting for the machine to be ready for use, en
JDJHWKHSRUWD¿OWHULQWKHJURXS
• <RXUPDFKLQHLVUHDG\IRURSHUDWLRQZKHQWKH%DULVWD
'DVKERDUGVKRZVWKHH[SHFWHGRSHUDWLQJSUHVVXUH
Time Temp Stm M
12.3 89.2 1.2b
5.2 COFFEE BREWING
NOTE: If your machine has been inactive for
more than an hour, before brewing, carry out an
empty run of about 100 ml. After 8 hours of in-
activity, run an empty dispensing operation for
about 1 minute on each group.
• 5HPRYHWKHSRUWD¿OWHUIURP\RXUPDFKLQHDQGHPSW\LW
RIWKHSUHYLRXVFRIIHHJURXQGV
• )LOOWKHSRUWD¿OWHUZLWKDSSUR[LPDWHO\JUDPVRI
ground coffee.