Only after the battery has been initially charged for up to 5 hours as indicated on Page 12 is the
Slinger Bag ready to be used on court.
Please follow these quick start operating guidelines
1. Position Slinger Bag on the court in your desired launching position. See our suggested positions
based on level of play on pages 22 & 23.
2. Open / Unzip the lower front panel in order to display the Ball Launcher.
3. Open / Unzip the top ball feeder panel. Make sure that nothing is obstructing the ball feeder. If all
is clear load up to a recommended maximum of 120 pickleballs.
4. On the front control panel adjust the control knobs to set the desired BALL SPEED, BALL FEED and
BALL SPIN. See our suggested positions based on level of play on pages 22 & 23.
On the right bottom side of the launcher (as you look at it) unzip the elevation control knob cover.
Adjust the elevation control knob to your desired launching angle - between 10º and 40º. See our
suggested positions based on level of play on pages 22 & 23.
5. Turn ‘ON’ the Launcher power switch on the front control panel.
6. With all of the controls set up, take the remote control and proceed to your playing position.
7. Point the remote control at the Launcher and press the top “On/Off” pickleball icon button once in
order to activate the ball feeder mechanism.
8. START PLAYING!
USER NOTE
Hook the open door panel on to the side of the Trolley Bag using the clip provided
on the left rear side as you look at the launcher.
QUICK START SLINGER BAG ONLY (NO OSCILLATOR)
USER NOTE
Slinger advises that the optimum ball launcher operation is achieved with 72
pickleballs.
USER NOTE
You will hear a single “beep” to signal that the launcher wheel has started. After 10
seconds you will hear a second “beep” signalling that the feeder plate is rotating and
the balls are about to commence launching.
4
Slinger Bag User Guide - Pickleball 2/2023
To Next Page
Loading...
