SMA Enwitec Sunny Island 4.4M - Installation Clearances

SMA Enwitec Sunny Island 4.4M

38 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

18_06_07_Battery Backup Distribution_10010371_ENG_V1.8 Seite -17- von -38-

200mm

200mm

4

00mm

1.200mm

200mm

5.2 Installation clearances

Minimum distances

Table of Contents

Default Chapter2
- Table of Contents2
1 About this Guidance4
- Scope of Application4
- Symbols Used5
2 Safety6
- Appropriate Usage6
- Safety Instructions7
- Symbols Used on the Type Label8
3 Scope of Delivery9
- Single-Phase Battery Backup Distribution (All-Pole Disconnection)9
- Three-Phase Battery Backup Distribution (All-Pole Disconnection)10
4 Electrical Connection11
- Installation Energy Meter / Home Manager11
- Single-Phase Distribution - All Pole Disconnection12
  - Circuit Diagram - Single-Phase Automatic Transfer Switch12
  - System Integration - Single-Phase - Automatic Transfer Switch13
- Three-Phase Distribution - All Pole Disconnection14
  - Circuit Diagram - Three-Phase Automatic Transfer Switch14
  - System Integration - Three-Phase Automatic Transfer Switch15
5 Mounting the Battery Backup Distribution16
- Selecting the Mounting Location16
- Installation Clearances17
- Dimensions and Cable Entry18
6 Connection Compartment - Layout Terminals21
- Single-Phase Battery Backup Distribution21
- Three-Phase Battery Backup Distribution22
7 Protective Conductor Connections (PE)23
8 Phase Coupling Within Single-Phase „IPC" Version25
9 Connecting the Grid - Main Supply26
10 Connecting the Distribution Board (Load/Pv)26
- Island-Mode (Backup Function)26
- Grid-Mode27
11 Connecting the Sunny Island's28
- Terminal Block X328
- Terminal Block X4/X528
12 Speedwire-Connection - Home Manager/Energy-Meter29
13 Initial Operation29
14 Disconnect from Voltage31
15 Maintenance and Cleaning (Spare-Fuse)32
16 How to Stock the Battery Backup Distribution33
17 Disposal33
18 Technical Data34
- Single-Phase BBDAP34
- Three-Phase BBDAP35
19 EC Declaration of Conformity36