Installation SMA Technologie AG
24 SB40TL_50TL-IEN081211 Installation Guide
5. Check both sides to ensure that it is correctly in
place.
In order to prevent the Sunny Boy being pulled off, you must also screw it to the wall. To do so,
proceed as follows:
1. Remove the Electronic Solar Switch by pulling it downwards.
2. Loosen all six non-removable lid screws and
remove the lid.
3. Drill through the rear wall of the housing.
4. Use a suitable drill bit at least 120 mm in length.
5. Insert a wall anchor of the correct size.
To Next Page
Loading...
