SMA SUNNY BOY 5000TL - 6.4.1 Checking the Country Configuration

Electrical Connection SMA Technologie AG
38 SB40TL_50TL-IEN081211 Installation Guide
The last change (switch or communication device) is always checked and accepted if applicable.
I.e. the switch position may not always show the actual country configuration.
6.4.1 Checking the Country Configuration
Check that the Sunny Boy is set to the installation country.
Check that the country configuration is correct via the display message when (re-)commissioning
(see section 7 „Commissioning” (Page 47)) or via the "SMA grid guard" measuring channel using
a communication device.
If necessary, change the setting via the "CntrySet" parameter using the communication device or via
the rotary switch (as described in section 6.4.2 „Setting Using a Rotary Switch” (Page 40))
according to the following table.
The settings in each parameter set are specified in the operation parameters. You can view these
using a communication device or download it from www.SMA.de.
(1) (2) Parameter set Display language Protection Country
0 0 Condition upon
delivery
Condition upon
delivery
depending on
parameter set
depending on
parameter set
0 1 is retained English depending on
parameter set
depending on
parameter set
0 2 is retained German depending on
parameter set
depending on
parameter set
0 3 is retained French depending on
parameter set
depending on
parameter set
0 4 is retained Spanish depending on
parameter set
depending on
parameter set
0 5 is retained Italian depending on
parameter set
depending on
parameter set
0 6 is retained Greek depending on
parameter set
depending on
parameter set
1 0 VDE0126-1-1 German yes Germany,
Switzerland
1 1 VDE0126-1-1 A
a)
German yes Germany
1 8 VDE0126-1-1 French yes Switzerland,
France
1 9 VDE0126-1-1 B
b)
* French France*
2 0 VDE0126-1-1 Italian yes Switzerland
2 8 AS4777* English no Australia