SMA Solar Technology AG Failure Search
Installation Guide SMC6-8TL-IEN101040 61
9 Failure Search
If the inverter displays other blink codes or error messages other than those described in the following
section, contact the SMA Serviceline
In the user manual provided, you will also find a description of the display messages during operation,
the status messages and measuring channels.
Do not try to carry out repairs other than those described here. Instead, use the SMA Solar
Technology AG 24-hour replacement service (the inverter will be ready for dispatch within 24 hours
and sent to a forwarding agency) and repair service
9.1 Blink Codes
9.2 Error Messages
When a disturbance occurs, the inverter generates a message, which depends on the operating mode
and the type of disturbance detected.
Green Red Yellow Status
Glows continuously Is not glowing Is not glowing OK (feeding operation)
Glows continuously Is not glowing Ground fault or varistor
defective
Glows continuously OK (initialization)
Flashes quickly
(3 x per second)
Is not glowing Is not glowing OK (stop)
Glows continuously Is not glowing Ground fault or varistor
defective
Flashes slowly
(1 x per second)
Is not glowing Is not glowing OK (waiting, grid
monitoring)
Briefly goes out
(approx. 1 x per
second)
Glows continuously Is not glowing Ground fault or varistor
defective
Is not glowing Is not glowing OK (derating)
Is not glowing Is not glowing Is not glowing OK (disconnection)
Glows / flashes Disturbance
Glows continuously Is not glowing Ground fault or varistor
defective
Glows / flashes Ground fault or varistor
defective and disturbance
To Next Page
Loading...
