EasyManua.ls Logo

Smart Start SmartMobile Insight - Troubleshooting; Unit wont turn on; Device messages

Smart Start SmartMobile Insight
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
SmartMobile
Insight
User Manual
Troubleshooting
Unit won’t turn on:
Plug in the charger to an electrical outlet and plug the
cable into the charger connection on the side of the
device.
If the battery is completely dead, it may take a few
minutes to charge enough to initialize the device (much
like a cellphone).
If the device was left in your car overnight in cold weather,
the device may be too cold to charge. Allow the device to
warm up above 32°F / 0°C. At this point, the device will
begin charging the battery.
If the battery has been removed, the unit will not turn on.
Removing the battery is considered tampering and will be
reported as a violation of your program.
Device messages
Please Blow Longer: This occurs when you blow too
quickly into the device. Try blowing longer and steadier.
Please Try Testing Again: This occurs when the fuel cell is
saturated. Try letting the device sit for a couple of minutes
and power down.
Do Not Inhale On The Inlet Port: This occurs when you
suck through the area where the mouthpiece goes. Please
do not inhale through the inlet port.
Do Not Inhale On The Exhaust Port: This occurs when
you suck through the area on the back exhaust. Please do
no inhale through the exit port.
Keep Face In View Of Camera: No face features were
found during the test. The camera lost face detection. Try
getting in a better lighted area eliminating shadows on
your face. If the problem persists, try letting the device
power down and try again.
TEST ABORTED Do Not Block Exhaust Port: This occurs
when you block the area on the back exhaust. Please do

Related product manuals