To Next PageTo Next Page
Need help?Do you have a question about the Smart Tracker GPS Vehicle Tracker and is the answer not in the manual?
General| Brand | Smart Tracker |
|---|---|
| Model | GPS Vehicle Tracker |
| Category | GPS |
| Language | English |
Explains the meaning of the red LED status for power and working.
Details the green LED status for GSM signal indication.
Describes the blue LED status for GPS signal reception.
Covers checking the device and preparing the SIM card before installation.
Provides guidance on covert installation and placement for optimal reception.
Lists the specifications and color coding for device wiring outlets.
Illustrates the complete wiring diagram for connecting the device.
Details wiring for power, ACC ignition, and tele-cutoff functions.
Explains the use of the USB cable for firmware updates.
Describes the MIC line connection for voice monitoring.
Explains the SOS line connection for emergency alerts.
Guides on setting the Access Point Name (APN) for GPRS connection.
Explains how to configure DNS or IP settings for platform connection.
Details commands to enable or disable GPRS data transmission.
Provides instructions for setting the device's time zone.
Explains how to set SOS numbers for alarms and calls.
Describes how to delete specific phone numbers from the device.
Guides on setting a center number for remote oil cut-off commands.
Explains how to remove the designated center number.
Details how to check current device parameter settings via SMS.
Provides SMS command to check GPRS status and APN settings.
Explains how to set the interval for GPRS data uploading.
Details setting the time for sensor alarm activation, like vibration.
Guides on resetting all parameters to default factory values.
Explains how to reboot the device to resolve issues.
Instructions for turning the device on and off correctly.
Methods for checking the vehicle's current location.
Details how to activate and what happens during an SOS alarm.
Explains the alarm triggered when the device's power is cut.
Describes the alert for the device's internal battery being low.
Details the alarm triggered by vehicle vibration when security is active.
Explains how to activate voice monitoring by calling the device.
Guides on how to remotely cut off the vehicle's fuel supply.
Instructions on how to restore the vehicle's fuel supply.
Details the alarm sent when the vehicle exceeds a set speed limit.
Troubleshooting steps when the device is 'logged off' from the platform.
Steps to resolve the device showing an 'offline' status on the platform.
Troubleshooting steps when the device's GPS is not locating properly.
Guidance on improving GPS signal reception in challenging environments.
Troubleshooting steps for poor GSM signal reception.
Addresses issues related to receiving tele-cutoff alarm SMS.
