REMOTE CONTROLLER
OPERATION
Before operating the camera, check if power
and other devices have been correctly
connected.
Power
In none-menu status, press this button to turn
on / off the camera.。
Home
Press HOME button, camera moves to initial
position where both pan and tilt angle is zero。
Camera Selection
Used to switch among 4 cameras, press 1-4
number buttons to control cameras with 1-4
addresses respectively. For example, press
button 1 to control the camera with address 1.
Default address of camera is 1, the remote
controller supports to control camera with
address 0 or 5~63.
Focus
Press “AUTO” button to switch to Auto Focus,
press “MANU” button to switch to Manual
Focus mode.
“ ” button to Focus Near
“ ” button to Focus Far
To Next Page
Loading...