PAN/TILT SPEED: 1，2，3，4，5，6，7，8 the
bigger the number is, the faster the speed is.
The speed is the fastest when in 1x zoom
compared to other zooming times.
High speed: 15°~50°（increased by every 5°）
Low speed: 4°~11°（increased by every1°）
PAN/TILT LIMIT: ON/OFF, once it is set as
ON, below limit value can be set.
UP: -30°~+90°, adjustable every 1°；
DOWN: -30°~+90°, adjustable every 1°；
LEFT: -170°~+170°, adjustable every 1°;
LIGHT: -170°~+170°, adjustable every 1°.
D-ZOOM LIMIT: X1, X2, X3, X4, X5, X6, X7,
X8, X9, X10, X11, X12.
PTZ TRIG AF: Turn ON / OFF the auto focus
when the camera pans / tilts / zooms.
POWER UP ACTION: PRESET 1, PRESET 2,
PRESET 3, PRESET 4, PRESET 5,
PRESET 6, PRESET 7, PRESET 8,
PRESET 9, HOME.
SYSTEM
DISPLAY INFO: Turn ON / OFF display of
pan / tilt angle and prompt message.
RATIO SPEED: When RATIO SPEED is set as
ON, at telephoto zoom settings, the pan and
tilt speeds will be slower for a given amount
of joystick deflection then at wide zoom
settings. This keeps the image from moving
too fast on the monitor when there is a large
amount of zoom.
PRESET FREEZE: When it is on, during a
regular preset call, the video will be frozen at
point A till Point B. At Point B, the video will
be displayed normally.
CVBS OUTPUT：LETTER BOX, CROP,
SQUEEZE
LETTER BOX: add a blank area in the
upper and lower portion of the image to
display video in 16:9 ratio, so can show
without distortion in 4:3 ratio monitor.
CROP: cut the left and the right side of 16:9
ratio image to get 4:3 ratio image.
SQUEEZE: compress the video signal
horizontally to get 16:9 ratio image without
distortion.
RS422 PORT: FULL-DUPLEX,
HALF-DUPLEX-1, HALF-DUPLEX-2
FULL-DUPLEX:RS422 full duplex mode,
connecting R + , R-, T + , T- interface of the
camera to control devices.
HALF-DUPLEX-1:RS485 half duplex mode,
in VISCA protocol, after executing the
command message, the camera does not
return confirmation / completion / error
To Next Page
Loading...