SMART Audio System navigation/multimedia - Click; Confirmation Tone; Switch-On Volume

X
Call up the volume settings menu
(Y page 22).
The entry on the right beside Naviga‐
tion shows the current setting.
X
Press Navigation in the menu.
A settings menu appears.
X
Press the = or Ì button to adjust
the volume fadeout. You can select values
between 0 (no fadeout), 1 to 5 (light to
strong fadeout) and 6 (full fadeout).
or
X
Turn cVd the control knob.
X
To confirm the setting: press OK.
The volume settings menu appears.
Adjusting the switch-on volume
X
Call up the volume settings menu
(Y page 22).
The entry on the right beside On vol‐
ume shows the current setting.
X
Press On volume in the menu.
A menu appears.
X
Press Last volume.
Depending on the previous status, the
function is switched on O or off ª.
When the function is switched on, the
switch-on volume is the volume at which
audio system navigation/multimedia was
last switched off. Last is then displayed
on the right beside On volume in the
menu.
or
X
Press Fixed on volume.
A settings menu appears.
X
Press the = or Ì button to adjust
the volume. You can select values between
0 (switched off) and 50 (loud).
or
X
Turn cVd the control knob.
X
To confirm the setting: press OK.
The volume settings menu appears.
Adjusting the volume of the confirma-
tion tone (beep)
Some functions, such as storing a radio
station, are acknowledged with a confir-
mation tone. You can adjust the volume of
the confirmation tone.
X
Call up the volume settings menu
(Y page 22).
The entry on the right beside Beep shows
the current setting.
X
Press Beep in the menu.
A settings menu appears.
X
Press the = or Ì button to adjust
the volume. You can set values between 0
(switched off) and 3 (loud).
X
To confirm the setting: press OK.
The volume settings menu appears.
Adjusting the click volume
Entries that you make by pressing briefly
on the screen are accompanied by a tone
(click). You can adjust the volume of this
click.
Volume settings
23
>> General settings.