Starting route simulation
X
Press Simulation mode in the "Route
information" menu (Y page 50).
The route is shown from the start (or pre-
vious position) to the destination.
Displaying trip info
X
Press Trip info in the "Route informa-
tion" menu (Y page 50).
You see the following information:
R
maximum speed
R
average speed
R
distance covered
R
driving time
R
total remaining driving time
R
total remaining journey distance
The bar underneath shows the following
information:
R
current height above sea level
R
current time (if route guidance is not
active)
R
remaining journey time to next desti-
nation (intermediate stop, final des-
tination)
R
remaining distance to next destina-
tion (intermediate stop, final desti-
nation)
R
estimated time of arrival at next des-
tination (intermediate stop, final
destination)
X
To close trip info: press &.
i
The information can also be shown by
pressing the field with the destination
information at the bottom of the map
(Y page 47).
Editing a route
Introduction
You can add additional destinations to the
route, optimise route guidance or change
the order of the destinations.
X
Press the arrow at the bottom left of the
map (Y page 47).
The navigation main menu appears.
X
Press Route planning.
The edit route menu appears.
The following functions can be selected:
R
adding a destination
R
optimising a route (available with four
or more destination entries)
R
changing the order of the destinations
within the route
R
loading/saving a route
Adding a destination
X
Press Alternative route.
The new destination menu appears.
X
Select destination entry.
Entering an address (Y page 36)
Last locations (Y page 42)
Current position (if available)
Special destinations (Y page 43)
X
Select option 1.
Favourites (Y page 43)
X
Press OK in the detailed information
menu (Y page 39).
The destination is entered in the edit
route menu.
52
Route guidance
>> Navigation.
To Next Page
Loading...
