SMART Audio System navigation/multimedia - Time Entry; Clock Settings

X
Select the desired colour scheme.
X
Press OK to confirm the selection.
The display appears in the selected col-
our scheme.
Clock settings
Introduction
Audio system navigation/multimedia sets
the time automatically if it has sufficient
GPS reception.
You can also set the time manually (e.g. if
there is no GPS reception or the reception
is insufficient). However, the time that you
enter will be overwritten when there is GPS
reception. The time zone and summer time
settings are not changed.
Calling up the "Time entry" menu
X
Press Extras in the main menu
(Y page 10).
X
Press Options in the menu.
The general settings menu appears.
X
Press Clock settings.
Setting the time
The time is shown in the status bar in the
radio display.
X
Call up the "Time entry" menu
(Y page 25).
X
Press Edit time.
X
Press the available numbers (shown in
white) one after another.
The colon between the hours and minutes
is entered automatically.
X
Press OK.
The setting is accepted and the "Time
entry" menu appears.
Setting the time format
You can set the format to 24-hour or 12-hour
(AM/PM).
X
Call up the "Time entry" menu
(Y page 25).
The entry on the right beside 12 hour
mode shows the current setting.
X
Press 12 hour mode.
The entry on the right beside 12 hour
mode changes.
Setting the time zone
X
Call up the "Time entry" menu
(Y page 25).
The entry on the right beside Time
zone shows the current setting.
X
Press Time zone.
A list appears for the selection of the
time zone. The currently selected time
zone is identified by the O symbol.
Clock settings
25
>> General settings.