Installing the Interactive Whiteboard 27
.
1. Connect the power cable to both the power supply and a power outlet.
2. Connect the SMART USB adapter cable to a USB port on your computer. Earlier, you
connected the other end of this cable to either the pen tray or the controller.
OR
If you ordered a straight-through DB9-to-DB9 serial cable, connect it to an available
serial port on your computer. Earlier, you connected the other end of this cable to
either the pen tray or the controller. You will need to select the computer’s serial port
in the SMART Board software after you’ve completed all connection procedures
(page 31).
NOTE: You may order a straight-through DB9-to-DB9 serial cable from SMART
Technologies. To do this, contact Technical Support (page 39).
OR
If you’re using the WC2 Wireless Serial Adapter (Part No. WC2-NA), connect the
second radio to your computer by following the instructions that came with the kit.
3. If you want to use the optional Display Control icon strip, peel off the back of the strip
to expose the adhesive, and then attach the strip to the front of the interactive
whiteboard.
NOTE: This functionality is only available with a Microsoft Windows operating system.
To complete the installation
Power Cable
Power Supply
NOTE: Your power cable
might look different because
your overlay comes with a
power cable that works with
your country’s power outlets.
To Next Page
