9!24 Helpful hints
Breakdown set
! Remove the stopper from the filler hose
and push the end of the hose onto the
tyre valve.
! Hold the bottle with the filler hose
pointing downwards and squeeze it.
! Press the entire contents of the bottle
into the tyre.
! Pull the hose off the valve and remove
any residual sealant from the valve,
rim and/or tyre.
! Screw the original valve insert (or the
replacement one if necessary) back
into the valve with the valve remover.
! Fit the compressor's air hose accu!
rately onto the valve.
! Plug the power connection into the 12!
volt power socket.
! Inflate the tyre to at least 1.8 bar (max!
imum 2.5 bar).
>Note!
Do not run the electric compressor for
more than six minutes. If you do so, there
is a risk of overheating!
!"#$%&$%'&#())*#+#,-.))/-0123456-789:%%;##<=4>=#DI##@4>>A%B6C#DE9#FG1'G&#D)).##/H*?#)/
To Next Page
Loading...
