Helpful hints 9!25
Breakdown set
>Note!
If a pressure of 1.8 bar cannot be gener!
ated, disconnect the compressor from the
wheel. Carefully drive the car 10 meters
forward or backward to distribute the
tyre sealant in the tyre.
Inflate the tyre again.
! Continue your journey immediately af!
ter removing the compressor, so that
the tyre sealant is distributed evenly
around the tyre's interior and can seal
the damaged point.
! After driving for about ten minutes,
check the pressure with the gauge on
the compressor.
Accident risk!
If the tyre pressure of 1.8 bar
cannot be achieved after five minutes,
the tyre is damaged too severely.
Do not drive any further! Air could oth!
erwise escape from the tyre. You could
cause an accident as a result. Notify a
qualified specialist workshop, e.g. a
smart center.
Accident risk!
Do not exceed a speed of 80 km/h
or 50 mph when you have repaired a tyre
with the tyre sealant.
The "max. 80 km/h" must be displayed
on the instrument panel within the
driver's field of view.
Your car's handling characteristics
may be impaired by the damaged tyre
even if it has been repaired using the
tyre sealant.
Accident risk!
If the tyre pressure has fallen
below 1.3 bar, the tyre is too badly dam!
aged.
Do not drive any further! Air could oth!
erwise escape from the tyre. You could
cause an accident as a result. Notify a
qualified specialist workshop, e.g. a
smart center.
!"#$%&$%'&#())*#+#,-.))/-0123456-789:%%;##<=4>=#D.##@4>>A%B6C#DE9#FG1'G&#D)).##/H*?#)/
To Next Page
Loading...
Need help?
General
