Radio Mode
i
You can find information on the
operating system and the basic
operation of the smart radio 10 in the
sections Overview of controls (Y page 6)
and Basic functions (Y page 8).
Switching on the Radio
X
Press the ON button.
The radio activates the last active
function.
If the last active function was radio
mode, the radio menu will appear. You
will hear the last station selected.
X
When another function is active, e.g. CD
mode: press the SRC button repeatedly
until the radio menu appears.
The radio switches to radio mode. You
will hear the last station selected.
Switching Wavebands
The following wavebands are available:
R
FM waveband (stereo)
87.7 – 107.9 MHz
R
AM waveband (mono only)
530 – 1710 kHz
Each of these wavebands is provided with
two pre-set groups, FM 1 and FM 2 or AM 1
and AM 2. Each pre-set group allows you to
store up to six stations.
X
To select an FM pre-set group: press the
FM button repeatedly until the desired
pre-set group appears.
The display cycles through the pre-set
groups FM 1 and FM 2.
X
To select an AM pre-set group: press the
AM button repeatedly until the desired
pre-set group appears.
The display cycles through the pre-set
groups AM 1 and AM 2.
Selecting a Station
Stations may be tuned in the following
ways:
R
using the station search (Y page 12)
R
using the station scan (Y page 12)
R
manually (Y page 13)
R
using the station pre-sets (Y page 13)
Tuning in a Station Using the Station
Search Function
X
Set the desired waveband.
X
Press the SEEK button
The station search starts and searches
forwards.
R
The search stops at the next station
that can be received.
R
If the end of the waveband is reached,
the search continues at the beginning
of the waveband.
R
If no station is found, the search stops
at the end of the waveband.
Tuning in a Station Using the Station
Scan
The station scan is available in all
wavebands. Searches are always performed
forwards.
12
>> Audio.
audio_ZA; 1; 6, de-DE
sabbaeu, Version: 2.11.4
2008-11-10T16:21:39+01:00 - Seite 12
To Next Page
Loading...
