X
Set the desired waveband.
X
To start the station scan: press the
SCAN button.
The station scan starts.
R
The station scan plays every station
identified for approximately eight
seconds and stops once it has reached
the station set before the scan was
started.
R
If the end of the waveband is reached,
the scan continues at the beginning of
the waveband.
X
To stop the station scan: press the SCAN
button.
If you stop the station scan before it has
found a new station, the radio sets the
last station identified.
Tuning in Stations Manually
You can tune in manually in all wavebands.
X
Set the desired waveband.
X
Press and hold the ý or þ arrow
button.
Manual tuning is selected and the
frequency changes in the desired
direction.
X
Release the button when the desired
frequency has been reached.
X
Fine tuning by increments: press the
ý or þ arrow button briefly
several times.
Tuning in a Station via the Station Pre-
Sets
X
Select the desired pre-set group (FM 1,
FM 2, AM 1 or AM 2).
X
Press one of the number keys 1 – 6.
The radio tunes in to the station stored
under the selected pre-set.
Storing a Station
Each pre-set group (FM 1, FM 2, AM 1, AM 2)
provides six pre-sets.
The following options allow you to store a
station:
R
manually, using the number keys (all pre-
set groups)
R
automatically, using the Autostore
function (FM 2 and AM 2 only)
Storing Stations Manually Using the
Number Pad
X
Select the desired pre-set group FM 1,
FM 2, AM 1 or AM 2.
X
Select a station
X
Press and hold the desired number key,
e.g. 4, until you hear a tone.
The currently set station is stored under
pre-set 4 in the pre-set group selected.
Storing stations using the Autostore
function
i
The Autostore function automatically
assigns receivable stations to the pre-
sets in the pre-set groups FM 2 and AM 2
in an order corresponding to the quality
of reception. Any channels stored
manually in these pre-sets will be lost.
X
To autostore FM stations: select the pre-
set group FM 2.
X
Press and hold the FM button.
X
To autostore AM stations: select the pre-
set group AM 2.
X
Press and hold the AM button.
X
The Autostore function scans the
waveband and stores the stations found in
the pre-set group selected.
>> Audio.
13
audio_ZA; 1; 6, de-DE
sabbaeu, Version: 2.11.4
2008-11-10T16:21:39+01:00 - Seite 13
Z
To Next Page
Loading...
