Need help?Do you have a question about the Smartgen HGM6100N Series and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Communication | RS485, CAN |
| AC Frequency | 50/60Hz |
| Storage Temperature | -40°C to +85°C |
| Crank Interrupt | Yes |
| Model | HGM6100N |
| Input Voltage | 8-35VDC |
| Operating Temperature | -25°C to +70°C |
| Standby Current | <10mA |
| Humidity | ≤ 95% (non-condensing) |
| Dimensions | 200*138*48mm |
Details the function and operation of each key on the controller panel.
Overview of the front panel layout, indicators, and display elements.
Explains the sequence of events for automatic genset start and stop operations.
Describes how to manually start and stop the genset using the controller.
Details the procedure for compelling the genset to start in an emergency situation.
Lists warning conditions that trigger alarms without stopping the genset.
Details shutdown conditions that cause the genset to stop and display an alarm.
Lists all configurable parameters with their ranges and default values.
Explains the functions assignable to programmable outputs 1-4.
Details the functions assignable to programmable inputs 1-5.
Guides the selection of sensors for temperature, pressure, and fuel level.
Outlines conditions for disconnecting the starter motor from the engine.
Instructions on using the fixing clips to mount the controller module.
Provides physical dimensions and panel cutout specifications.
Details controller connections for Cummins ISB/ISBE engines.
Provides connection details for Cummins QSL9 engines.
Outlines connections for Cummins QSM11 (CM570) engines.
Specifies connections for Cummins QSX15-CM570 engines.
Explains connections for Cummins GCS using RS485-MODBUS.
Details connections for Cummins QSM11 (common J1939).
Outlines connections for Cummins QSZ13 engines.
Specifies connections for Detroit Diesel DDEC III/IV engines.
Details connections for Deutz EMR2 engines.
Provides connection details for John Deere engines.
Outlines connections for MTU engines with SMART modules.
Specifies connections for MTU engines with SAM modules.
Details connections for Perkins engines.
Outlines connections for Scania engines.
Specifies connections for Volvo EDC3 engines.
Details connections for Volvo EDC4 engines.
Outlines connections for Volvo-EMS2 engines.
Specifies connections for Yuchai engines.
Details connections for Weichai engines.
To Next Page