EasyManua.ls Logo

SmartPower SBP Plus Series - Replacing the Battery; Battery Replacement Safety; Battery Replacement Procedure

SmartPower SBP Plus Series
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
REPLACING THE BATTERY (1000VA/1500VA only)
Replacement of batteries located in an OPERATOR ACCESS AREA.
1. When replacing batteries, replace with the same number of the battery
2. CAUTION!  Risk of Energy Hazard! Before replacing batteries, remove
conductive jewelry such as chains, wrist watches, and rings. High energy
conducted through these materials could cause severe burns.
3. CAUTION!  Do not dispose of batteries in a fire. The batteries may explode
4. CAUTION!  Do not open or mutilate batteries. Released material is harmful to 
the skin and eyes. It may be toxic.
5. CAUTION!  A battery can present a risk of electrical shock and high short 
circuit current. The following precautions should be observed when working on 
batteries:
1) Remove watches rings, or other metal objects.
2) Use tools with insulated handles.
CAUTION - RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING
TO LOCAL REGULATIONS.
BATTERY REPLACEMENT PROCEDURE
1.Turn off and unplug all connected equipment.
2.Turn the UPS off and unplug it from the AC power source.
3.Turn the UPS on its side.
4.Remove the screws on the bottom of the front panel and lay aside
5.Remove the front panel of the UPS: pull and lift it.
6.Take out the battery compartment covert.
7.Disconnect the battery wires from the battery.
8.Remove the battery from the compartment.
9.Put the battery back into the compartment.
10.Install the replacement battery by connecting the red wire (+) and black wire
(-) to the same color connectors from the battery pack.
11.Take in the battery compartment cover.
12.Fit the front panel on and tighten the retaining screws
13.Recharge the UPS for 8-16 hours to fully charge the battery.
 
REMINDER: Batteries are considered HAZARDOUS WASTE and must be
disposed of properly. Most retailers that sell lead-acid batteries collect used
batteries for recycling, as required by local regulations.
For battery replacement instructions for models 450 to 800 refer to our
support page at http://smartpowersystems.com/support-2/battery-replacement/

Related product manuals