20
ADMIN PASSWORD
The Admin Password is a specic security code for administrator to change the advanced settings.
The default admin password is 123456.
Please use this function to change the default admin password into your personal admin password.
For the protection of your system conguration, every time you change the advanced settings, you
need to enter the admin password. Please change the admin password periodically.
EMAIL ALERT
When motion detection is enabled and system detects movement:
- With Push Notication enabled, system will send out notication message to user’s mobile device.
- With Email Alert enabled, system will send out Email to alert user the event.
TIME ZONE
The drop-down list shows the world time zone. Select the time zone that will work the best for you.
DAYLIGHT SAVING
Enable/Disable the daylight saving function.
DEVICE SECURITY CODE
The Security Code is for remotely accessing the camera and by default the security code is
123456. For maximum security purpose please change the default security code.
1. Type in the old password.
2. Type in the new password and conrm the new password again.
3. Tap OK to save the setting.
Note:
If you forgot your admin password, please long press the reset button for 5 seconds to
restore the password into factory default value 123456 (please refer
to the Camera Overview section). All settings will be restored to factory default. You will
need to congure your camera Settings.
Note:
By default, the system has been limited to send out the email alert every 1 minutes to
prevent overloading user’s email account.
Note:
1. Change password in system information page accordingly.
2. If you forget the Device Security Code, please hold down the reset button (P.8) for
5seconds to reset the system to factory default. All settings will be restored to factory
default. You will need to congure your camera from the start.
To Next Page
Loading...
Need help?
General
