74 GB
Note: For details and more information, please refer to the included
tutorial CD
4
.
Connecting the camera (see Fig. B)
Connect the Ethernet cable
8
with the router.
Plug the connector of the power supply
7
into the camera
1
.
Plug the power supply
7
into the socket.
Wait about 45 seconds after connecting to the electric circuit. Once
the red and green LED on the camera light up, it is connected to
the network.
The red LED indicates the camera is connected with the power
supply. The green LED indicates the camera is connected with the
router.
Note: To use the camera to record, insert an SD card in the SD slot
(see Fig. B).
Open the rubber cover.
Slide the SD card, pins down, into the SD slot
11
.
Carefully push the SD card against the resistance of the spring.
The SD card is now locked in place.
To remove the SD card, lightly push against the SD card using
your fingernail.
The spring will now slightly push the SD card out of the SD slot
11
.
The SD card can now be removed.
Close the rubber cover to prevent water from entering.
To Next Page
Loading...
Need help?
General
