- 6 -
No. JXC※-OMU0029-A
2. Product Outline
2.1 Product features
The followings are the main functions of this controller:
Electric actuator Control
Positioning operation and Pushing operation, at a specific speed and force, of the electric
actuator are possible by controlling the Step motor (24 VDC servo).
Operation and settings are available with the controller.
Settings can be altered and operation can be run from the controller. Adjustments of the position,
speed, acceleration and test runs are available without the teaching box, PC, and PLC.
Specified force operation
Control the pushing force (or the pressing force) of the electric actuator.
Power supply separation input
The power supply is separated into the drive power and the control power. Therefore, even when
the drive power is off, if the control power is on, the position information from the encoder will be
maintained and the serial communication and parallel I/O control are still available.
Automatic sequence function of the return to origin position
Return to origin position is available through I/O signal combination.
Alarm detection function
Automatically detect the abnormal conditions and output the appropriate alarm signal via the
serial interface and parallel I/O.
14 points positioning / pushing is available
Through the combination of parallel I/O inputs, 14 points (position number 1 to 14(E)) of
positioning / pushing are available. The speed and acceleration of the positioning can be set by
the switch for each operating direction.
Data input method
Parameter settings, test runs, and alarm resets can be performed by the controller.
To Next Page
Loading...
Need help?
General
