If you have another IP address listed, then the PC may not be configured for a DHCP connection.
Please refer to Chapter 4 | Configure your Computer for information.
Once you have confirmed your computer is configured for DHCP, then please follow the steps below.
1. Open a DOS window as described above.
2. Type “ipconfig /release” (without the quotes)
3. Then type “ipconfig /renew” (without the quotes)
Once you are able to get a valid IP address from the Barricade Router, then you can now access
the web-based Administration pages.
If you still are not getting an IP address from the Barricade, please reset the router as outlined in
Chapter 2 and follow the steps outlined in this appendix again.
If you still cannot access the router once you have reset it, please contact SMC Technical
Support.
To Next Page
Loading...
