A.4 | I have a Dynamic IP connection and I can’t get online
Most cable companies use a Dynamic IP configuration to provide Internet access. If you have this
type of connection, and are unable to get connected, please follow the steps outlined below:
1. Unplug the power from your Cable or DSL modem for 2 mins.
2. Confirm that your Barricade router is configured for a Dynamic IP configuration
3. Plug the power back into your Modem.
4. Wait for your Modem to connect to the network, and then click on the status page of the
router to confirm that you are online.
The reason this process works is because certain broadband connections require a MAC address to
gain network access. This MAC address can be changed by following the above process to re-set the
approved MAC address to the MAC address of the Barricade router.
To Next Page
Loading...
