Configuring the Wireless Barricade g Router
40
• From IP Address
Input the last three digits of the first IP Address from the range of
IP addresses that you would like to exempt from this policy
enforcement.
Note: The default IP address of the Wireless Barricade is
192.168.2.1. The IP address that can be assigned to a
PC workstation on the network is 192.168.2.x (where x
means 2–254). See “Configuring Client TCP/IP” on
page 11.
• To IP Address
Input the last three digits of the last IP Address from the range of
IP addresses that you would like to exempt from this policy
enforcement.
Note: You also need to make sure that Exempt LAN Client
Option is set to Enable. Be sure to press the APPLY
button after completing the entry.
To Next Page
Loading...
Need help?
General
