SMC Networks EX600-ED Series User Manual

-52-
No. DOC1045423
■SI unit parameters (Valve related)
No.
Parameter
Definition
Item
Content
Default
setting
Parameter
setting range
1
Monitor short
circuit (out)
Generates error
when the short
circuit of the valve
is detected.
Enable
Generates an error.

Unit
Disable
Does not generate an
error.
2
Restart after
valve output
short circuit
Restore the setting
of short circuit
detection error
after the valve
short circuit is
cleared.
Auto
Error is automatically
cleared when the short
circuit is fixed.

Unit
Manual
Even when the short
circuit is fixed, error is not
cleared until the power is
supplied again.
3
Fault mode
1
Sets the output
when
communication
error is occurred.
Clear
Turn off the output

Channel
Hold
Hold the output
ForceON
Turn on the output
forcefully
4
Idle mode
1 2
Sets the output
during
communication
idling.
Clear
Turn off the output

Channel
Hold
Hold the output
ForceON
Turn on the output
forcefully
5
Monitor valve
ON/OFF
counter limit
Generates error
when the ON/OFF
count exceeds the
set limit value.
3
Enable
Generates an error.
Limit value: 1 to 65535
4
Channel
Disable
Does not generate an
error.

6
Valve ON/OFF
counter clear
5
Clears the valve
ON/OFF counter to
zero.
-
-
-
-
1: This function is valid only when “Hold/Clear priority setting” of the system parameter (page 51) is set to “Via software”.
2: Some PLC does not support an idle mode.
3: The count is memorized every hour. When the power supply is turned on again, counting starts from the last value memorized.
4: Times for setting is set value × 1000 times.
5: Refer to “Counter value” of Index 50y3:0 in the CoE object dictionary (108 page) or the Web server (page 121) for the clear method.

SMC Networks EX600-ED Series Specifications

General

Brand	SMC Networks
Model	EX600-ED Series
Category	Industrial Equipment
Language	English