SMC Networks ZL112A Series

Questions and Answers

A
aaroncoxAug 9, 2025
What to do if SMC Networks ZL112A vacuum fails over time after initially working?
- K
  Kenneth BrownAug 9, 2025
  If your SMC Networks Industrial Equipment experiences vacuum failure over time, even after initially working, consider these potential causes and solutions: * If the suction filter is clogged due to dust, replace the filter element and consider increasing the number of suction filters. * If the silencer is clogged due to foreign matter in the supply air, clean the supply air, control drainage, add an air filter and mist separator, or replace the silencer. * If the nozzle and diffuser are clogged, remove any foreign matter and mount an air filter on the supply side to prevent it from happening again.
M
Michael GarciaAug 15, 2025
Why is the adsorption response of my SMC Networks ZL112A not quick enough?
- M
  Miss Carol PowellAug 15, 2025
  If the adsorption response of your SMC Networks Industrial Equipment isn't quick enough, it could be due to: * The internal capacity of the circuit on the vacuum side being too large for the ejector performance. To resolve this, reduce the internal capacity of the vacuum circuit or change to an ejector with larger suction flow. * The set vacuum pressure for suction verification being too high. To resolve this, optimize the lifting force and lower the setting for suction verification of vacuum pressure as much as possible.
M
masonsamanthaAug 21, 2025
How to resolve vacuum pressure fluctuation in SMC Networks Industrial Equipment?
- R
  rgonzalezAug 21, 2025
  If you're experiencing vacuum pressure fluctuation with your SMC Networks Industrial Equipment: * If the supply pressure fluctuates, install a tank in the compressed air line on the supply side and reduce the air consumption of other equipment. * If the generated vacuum pressure fluctuates, making the exhaust noise intermittent at a certain supply pressure range, increase or decrease the supply pressure a small amount. This phenomenon is peculiar to ejectors and occurs when the supply pressure is slightly lower than the standard.
P
pachecoangelaNov 2, 2025
What to do if SMC Networks ZL112A fails to adsorb during the trial run?
- J
  Jonathan OrozcoNov 3, 2025
  If your SMC Networks Industrial Equipment fails to adsorb during the trial run, consider these potential causes and solutions: * If the adsorption area is too small, increase the lifting force by increasing the pad diameter or the number of pads. * If vacuum pressure is too small due to leakage, try to reduce the vacuum leakage by increasing the vacuum pressure. You could also change the pad configuration or material, or change to a more suitable pad if the workpiece is thin. * For small vacuum pressure due to workpiece permeability, check the vacuum pressure and suction flow. Try changing to an ejector with larger suction flow. * If the vacuum pressure is too small due to leakage from the vacuum piping, repair the vacuum leaking part. * If the suction flow is too small, change ...
K
Kendra LeeNov 26, 2025
What to do if the work piece is not released smoothly by SMC Networks ZL112A?
- K
  Karl Brown MDNov 27, 2025
  If the work piece is not released smoothly by your SMC Networks Industrial Equipment: * If the vacuum break flow is insufficient, open the vacuum break flow adjusting needle. For ejectors with individual ports for release pressure (PD) and supply pressure (PV), increase the pressure at the release pressure port. * If the vacuum pad surface is worn out and sticky, replace the vacuum pad. Consider revising the material and configuration of the vacuum pad, or use a special pad with a blasted adsorption surface. * If the vacuum pressure is too high, decrease the supply pressure to lower the vacuum pressure, or decrease the pressure in the piping on the vacuum side with a vacuum regulator. * If the work piece sticks to the pad due to static electricity, use a conductive pad. * If the...