Need help?Do you have a question about the SMC Networks VR2110 and is the answer not in the manual?
General| Brand | SMC Networks |
|---|---|
| Model | VR2110 |
| Category | Industrial Equipment |
| Language | English |
Take measures to prevent potential danger caused by actuator operation, such as cover installation.
Ensure sufficient space is available for product maintenance during installation.
Provide ventilation for confined areas to prevent pressure buildup and release heat.
Ensure the product is used only with compressed air within specified pressure/temperature ranges.
Implement measures to prevent drainage freezing and moisture issues in low temperatures.
Stop operation if air leakage increases or the equipment malfunctions; check mounting.
Use static piping, ensure proper pipe flushing, and secure sufficient tubing length.
Product is lubricated for life; use Class 1 turbine oil ISO VG32 if lubrication is needed.
Use clean compressed air; install filters, aftercoolers, or drain catches as needed.
Avoid corrosive gases, vibration, direct sunlight, and heat sources; protect from splashing liquids.
Confirm safety measures before servicing; cut pressure and power; exhaust air.
Use regulated air with a regulator for input signal air to ensure stable delay times.
Operate the time delay adjusting handle by hand only; do not turn off input signal before delay.
Explains setting the time delay by rotating the handle, noting clockwise increases delay.
Details how input signal pressure affects the time delay, with graphs shown.
Describes reset time variation based on signal valve, pressure, and piping length.
To Next Page
