SMC Networks EX600-ED Series User Manual

-66-
No. DOC1045423
■Analogue Input/Output unit parameters (continued)
No.
Parameter
Definition
Item
Content
Default
setting
Parameter
setting range
8
Monitor lower
limit
Generates error
when the input or
output value falls
below the user
setting value.
Enable
Generates an error.
1
Channel
Disable
Does not generate an
error.

Scale setting
value lower
limit
Sets the scale
lower limit.
Generates error
when the input or
output value falls
below the lower
limit.
Enable
Generates an error.
Value: -32767 to 32766
Disable
Does not generate an
error.
Value: -32767 to 32766

Value: 0
9
Fault mode
2
Sets output when
communication
error is occurred.
Enable
Output will be user fault
value.
1
Channel
Disable
Output will be held last
state.

10
Idle mode
2 3
Sets the output
during
communication
idling.
Enable
Output will be user idle
value.
1
Channel
Disable
Output will be held last
state.

1: Set value shall be set per analogue input/output range within settable range in the next page table.
When the analogue input/output range is changed, check the set value, and change it to an appropriate value.
2: This function is valid only when “Hold/Clear priority” of the system parameter (page 51) is set to “Via software”.
3: Some PLC does not support an idle mode.

SMC Networks EX600-ED Series Specifications

General

Brand	SMC Networks
Model	EX600-ED Series
Category	Industrial Equipment
Language	English