136 Operation (continued)
To raise the stylus from the record move the
control lever back to its original position. When
the arm is not in use it should always be
returned to the armrest for safety.
137 Adjusting height of lift
The raising and lowering control is set to suit
the majority of cartridges but the height raised
above record can be changed to meet
individual needs. The small hole in the centre of
the arm lift provides access to the adjustment
screw. Insert the long leg of the 0.89mm A/F
wrench through this hole to engage the screw.
Clockwise rotation will decrease the height of
lift; anti-clockwise rotation will increase it.
The adjustment is sensitive so the wrench
should only be turned a few degrees at a time.
Apply firm downward pressure to the arm lift
after each clockwise rotation of the adjustment
screw.
138 Cleaning the arm lift
If the arm drifts outwards during raising or
lowering it indicates contaminant on the rubber
pad. To restore positive working, wipe the pad
with a damp cloth and repeat with paper tissue
until dry. Clean the underside of the tone arm in
the same manner where it contacts the rubber
pad.
22
To Next Page
Loading...