Need help?Do you have a question about the SME M2 Series and is the answer not in the manual?
General| Brand | SME |
|---|---|
| Model | M2 Series |
| Category | Accessories |
| Language | English |
Details steps for preparing the turntable deck for arm installation, including marking and drilling.
Instructions for attaching the tonearm assembly to the prepared mounting board using supplied hardware.
Guide to connecting cartridge leads, specifying color coding and ensuring proper fit on terminals.
Instructions for replacing cartridge leads, referencing part numbers and correct color coding.
Steps to attach the headshell to the tonearm, aligning keyways and securing the clamp bolt.
Procedure for detaching the headshell from the tonearm using the clamp bolt and wrench.
Balancing the arm by adjusting the counterweight to achieve a level or slightly low front end.
Setting VTF by rotating the balance weight, using indicator marks for precise force application.
Adjusting tonearm height using the VTA thumbwheel to set the correct vertical angle.
Setting stylus azimuth by viewing reflection on a mirror to ensure verticality.
Aligning the tonearm to the record groove using a protractor for optimal tracking.
Adjusting the armrest position for convenient access and safe resting of the tonearm.
Setting the anti-skate force by threading filament and placing loop in groove corresponding to VTF.
Guidance on lowering the stylus onto the record using the control lever for smooth descent.
Modifying the arm lift height using an adjustment screw to suit different cartridge heights.
Procedure for cleaning the arm lift's rubber pad and tonearm underside for smooth operation.
To Next Page