EasyManuals Logo

Smeg BCC01 User Manual

Smeg BCC01
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
EN - 11
EN
Descaling
The coffee machine signals when it is
necessary to carry out a descaling cycle based
on the set water hardness (For the setting of
the water hardness, see the “Setting the water
hardness” paragraph).
If the LED (25) lights up steadily, it means
that a descaling cycle is necessary, so as not
to alter the taste of the coffee and damage the
machine. However, coffee and further drinks
may continue to be dispensed for a limited
number of cycles.
If the LED (25) ashes, it means that a
descaling cycle is mandatory to proceed with
further dispensing of drinks.
To carry out a descaling cycle, proceed as
follows:
Place a container with a capacity of at least
1.4l under the dispenser (11).
Make sure that the
White
program with
white illuminated keys is selected.
Fill the tank (5), up to the “MAX” level, with a
solution of water and descaler in the doses
recommended by the manufacturer
.
With the machine ready for use, press
the keys (20) and (18)
simultaneously for at least 3 seconds. The
key (18) ashes with an orange light
and the LED (25) has a xed light for
the entire duration of the descaling cycle.
Stay near the machine for the entire duration
of the descaling cycle since you may be
required, for example, to ll the tank (5).
The entire cycle lasts approximately 30
minutes.
During the descaling cycle, the machine will
take a few breaks to allow the descaler to
act effectively. Wait for the end of the cycle.
The descaling cycle ends when there is no
more solution in the tank (5), the key (18)
turns white and the LEDS (21)
and (25) remain lit.
Pour clean water into the tank (5) up to the
“MAX” level to carry out the rinse cycle,
then press the button (18) to start the
rinse cycle, the button (18) ashes
and the LED (25) lights up steadily for
the entire duration of the washing cycle.
The rinse cycle ends when the keys light up
white.
If, at the end of the descaling
process, the LED (25) remains
permanently lit, it indicates that
a new descaling cycle must be
carried out since the quantity
of descaling solution that was
used was insufcient for complete
cleaning.
Personal injury hazard.
The descaler contains acids that
can irritate the skin and eyes.
Follow the manufacturer's
instructions and safety warnings
on the packet scrupulously in
the event of contact with skin or
eyes.
Use descaler products
recommended by Smeg to
prevent damage to the coffee
machine.
Cleaning and maintenance

Other manuals for Smeg BCC01

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Smeg BCC01 and is the answer not in the manual?

Smeg BCC01 Specifications

General IconGeneral
Product typeEspresso machine
Built-in grinderYes
Capacity in cups1 cups
Grinder capacity150 g
Coffee input typeCoffee beans, Ground coffee
Coffee maker typeFully-auto
Country of originChina
Appliance placementCountertop
Water tank capacity1.4 L
Maximum operating pressure19 bar
Reservoir for brewed coffeeCup
AC input voltage220–240 V
AC input frequency50 - 60 Hz
Auto power off after (max)20 min
Package depth265 mm
Package width495 mm
Package height445 mm
Package weight7000 g
Quantity per pack1 pc(s)
Cappuccino makingNo
Control typeButtons
Product colorRed
Housing materialAluminium, Plastic
Pallet weight168000 g
Quantity per pallet24 pc(s)
Pallet GTIN (EAN/UPC)8017709301002
Quantity per pallet layer6 pc(s)
Number of layers per pallet4 pc(s)
Pallet net width800 mm
Pallet net height1900 mm
Pallet net length1200 mm
Pallet net weight120000 g
Weight and Dimensions IconWeight and Dimensions
Depth433 mm
Width180 mm
Height336 mm
Weight5000 g

Related product manuals