Smeg BCC01 User Manual

EN - 14
Problem Possible causes Solution
The machine stops when
dispensing.
Tank removed during
dispensing or water under
the minimum threshold.
Make sure the tank is
correctly assembled or ll
with water.
The side door was opened
during dispensing.
Close the side door again.
Alarm 21 not on
but water missing.
Incorrect water reading in
the tank due to lime scale
inside the tank.
Thoroughly clean and
reassemble the tank. Run a
descaling cycle if needed.
Water erroneously poured
in the tank gap.
Remove the tank and
thoroughly dry its
compartment.
Coffee is not hot.
Cups were not pre-heated. Heat cups by rinsing them
with hot water (Note: the hot
water function can be used).
Coffee is weak or with
little cream.
Coffee too roughly ground. Turn the knob counter-
clockwise to tighten the
coffee grinders. Warning: to
avoid machine damages, we
strongly recommend you turn
the knob when the machine
is in the grinding phase.
Dispensing when there are
no more beans.
Fill the bean container and
dispense coffee again.

Smeg BCC01 Specifications

General

Product type	Espresso machine
Built-in grinder	Yes
Capacity in cups	1 cups
Grinder capacity	150 g
Coffee input type	Coffee beans, Ground coffee
Coffee maker type	Fully-auto
Country of origin	China
Appliance placement	Countertop
Water tank capacity	1.4 L
Maximum operating pressure	19 bar
Reservoir for brewed coffee	Cup
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz
Auto power off after (max)	20 min
Package depth	265 mm
Package width	495 mm
Package height	445 mm
Package weight	7000 g
Quantity per pack	1 pc(s)
Cappuccino making	No
Control type	Buttons
Product color	Red
Housing material	Aluminium, Plastic
Pallet weight	168000 g
Quantity per pallet	24 pc(s)
Pallet GTIN (EAN/UPC)	8017709301002
Quantity per pallet layer	6 pc(s)
Number of layers per pallet	4 pc(s)
Pallet net width	800 mm
Pallet net height	1900 mm
Pallet net length	1200 mm
Pallet net weight	120000 g

Weight and Dimensions

Depth	433 mm
Width	180 mm
Height	336 mm
Weight	5000 g