EN - 6
At the rst use it is recommended to
make at least one coffee to make a
complete break-in of all the circuits.
We recommend setting the water
hardness upon first use. Please
see the “Water hardness settings”
paragraph for this reason.
Remember to reassemble the tray
(14) at the end of any dispensing.
After 30 minutes of non-use, the
machine switches off. If it has made
at least one coffee, it performs a
self-cleaning cycle. Press the button
(9) to switch on the machine.
Change of dispensing program
The machine has two dispensing menus in its
memory: White and Orange. To switch from
one program to another, press the key (26).
In the White menu all the keys are illuminated
in white, in the Orange
menu, all the keys are
illuminated in orange.
For the specic functions of each menu, refer
to the paragraph “Description of controls and
alarms”
Turning off the machine the setting of
the
White or Orange
dispensing
menu remains in the memory at the
next restart.
Dispensing a drink
• It is possible to adjust the position of the
dispenser (11) according to the cup used.
For very high cups it is possible to remove
the drip tray (14).
• Place a cup or large cup under the
dispenser.
Use
BEFORE FIRST USE
(Fig. D-E-F)
• Unpack the appliance carefully and remove
all packaging materials.
• Rinse the following removable components
with warm water: water tank (5) lids (2,4),
door (8) grounds container (12), drip tray
(13), drip trays (14,15), cup holder (16)
and infuser unit (17).
Before use, check that all
components are integral and have
no cracks.
ASSEMBLY OF COMPONENTS
(Fig. E)
• Place the machine on a at surface and x
the drip tray
(14).
• Connect the power supply cable to the
socket on the rear of the machine and the
other end to a power socket
.
USE (Fig. E-F-G-H)
• Lift the tank cover (4) and pour fresh water
in the tank (5) being sure not to exceed the
indicated ‘Max’ level. Replace the water
tank cover when full (4).
• Lift the coffee bean container lid (2) and
introduce the coffee beans into the container
(3).
• Check that the drip tray (14) is correctly
positioned. Make sure that the tray which
can be washed in the dishwasher (15) is
correctly inserted inside it and mount the
mug holder (16).
• Press the button (9), the machine starts the
heating phase and the keys light up ashing
in sequence. At the end of the heating, a
self-cleaning cycle of the internal circuits is
carried out and, once the cycle is nished,
the machine is ready to be used.
To Next Page
Loading...
Need help?
General
