EN - 11
EN
Cleaning the water tank (5)
• Remove the lid (4) and remove the tank (5)
from the machine using the appropriate
handle.
• Clean the tank (5) in running water with
neutral dish detergent and reassemble it in
the machine.
The presence of lime scale inside
the tank could cause the appliance
to malfunction. Make sure the tank
is always clean and without lime
scale stains.
Cleaning the brewing group (17)
We recommend cleaning the
brewing group at least once a
week.
• The coffee machine indicates when brewing
group cleaning is recommended (steady lit
LED 30).
• With the machine on, press the lower part
of the door (8) until it is released and slide
it out from the top.
• Press the two release clips (34) located on
the sides of the infuser (17) and remove it
from the machine
(Fig.I).
• Wash the brewing group (17) with running
water and dry it.
• Thoroughly clean its housing and the duct as
well, using the cleaning brush (19) supplied,
as in Figure I.
• Dry thoroughly before re-mounting the
various components.
• Ret the service door (8) making sure it is
correctly positioned.
Open the door and clean the
brewing unit while the machine is
on. This is the only way of resetting
the counter.
The counter resets at least 10
seconds after opening the various
components and LED 30 turns off.
We recommend running a manual
circuit cleaning cycle whenever this
operation is performed.
Please see paragraph “Manual
rinse” for this reason.
Do not wash the brewing group
in the dishwasher in order not to
damage it permanently.
Coffee powder residue can be found
in the brewing group compartment.
We recommend thorough cleaning
whenever cleaning the brewing
group. Use the supplied brush
to remove any residue from the
brewing group compartment.
Dry all components and internal
parts using a dry cloth before
closing the side door.
Steam wand cleaning (18)
• Wait for the steam wand (18) to cool before
operating.
• Remove the lower part (35) of the steam
wand by turning it anticlockwise to release
it then pull it downwards.
• Use the supplied cleaning needle (20) to
remove any encrustations from the steam
outlet.
• Clean with running water and reassemble
everything in the reverse order.
Cleaning and maintenance