User instructions
END PROGRAM
When the program finishes, a buzzer sounds
briefly and all the
PHASES/PROGRAM
lights
(10)
flash.
Press any of the
SELECTION PROGRAMS
buttons
(2)
, stops the light
flashins, and the dishwasher is now ready to perform a new cycle;
opening and shutting the door or switching the appliance off and on has
the same effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
• press the
START/PAUSE
button
(5)
, the light of the current phase
goes out;
• keep the button pressed until the
PHASES/PROGRAM
lights
(10)
come on (confirmation buzzer).
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “
I
NTERRUPTION OF A PROGRAM
”);
• select the new program;
• to press again the
START/PAUSE
button
(5)
to make start the new
program.
To Next Page
Loading...
