Smeg FAB38 - Error Codes and Diagnostics

33
EN
Before calling after-sales service
ERROR
TYPE
MEANING WHY WHAT TO DO
E01
Sensor
warning
Call Service for assistance as soon as possible.
E02
Sensor
warning
Call Service for assistance as soon as possible.
E03
Sensor
warning
Call Service for assistance as soon as possible.
E06
Sensor
warning
Call Service for assistance as soon as possible.
E07
Sensor
warning
Call Service for assistance as soon as possible.
E08
Low
Voltage
Warning
Power supply
to the device
has dropped to
below 170 V.
--This is not a device failure, this error helps to prevent dam-
ages to the compressor.
--The voltage needs to be increased back to required levels
If this warning continues an authorised technician needs to
be contacted.
E09
Freezer
compart-
ment is
not cold
enough
Likely to occur
after long term
power failure.
1. Set the freezer temperature to a colder value or set Super
Freeze. This should remove the error code once the required
temperature has been reached. Keep doors closed to im-
prove time taken to reach the correct temperature.
2. Remove any products which have thawed/defrosted dur-
ing this error. They can be used within a short period of time.
3. Do not add any fresh produce to the freezer compartment
until the correct temperature has been reached and the error
is no longer.
If this warning continues an authorised technician needs to
be contacted.