Why is my Smeg Washer/Dryer leaving too much water in the fabric conditioner compartment?
R
Rachel HughesSep 9, 2025
If your Smeg Washer/Dryer leaves too much water in the fabric conditioner compartment or doesn't use all the fabric conditioner, check that the detergent drawer siphons are correctly fitted and not fouled.
H
hmorseSep 12, 2025
How to remove traces of detergent on laundry from Smeg LSTA147SSA Washer/Dryer?
S
Sarah BradleySep 12, 2025
To remove traces of detergent on laundry from your Smeg Washer/Dryer, select the Rinse programme or brush the laundry.
R
Ronald GomezSep 13, 2025
Why is water not pumped out after last rinse in delicate fabrics and wool wash programmes in Smeg LSTA147SSA?
J
Johnathan SaundersSep 14, 2025
The water is not pumped out after the last rinse in delicate fabrics and wool wash programmes in your Smeg Washer/Dryer because a pause is programmed into the washing programme to prevent creasing of fabrics. To pump out water, proceed as described in 'Programme End' point.
C
Caroline WoodsSep 16, 2025
Why is no water visible in the washing drum of my Smeg Washer/Dryer?
O
owaltersSep 16, 2025
The absence of visible water in the washing drum of your Smeg Washer/Dryer is not a malfunction. New appliances use very little water to achieve the same washing and rinsing results, so the water level is below the level of the glass in the door.