Smeg PLA8743X - End of Program; Interrupting a Program; Changing the Current Program

12 Rev 0.0
USER INSTRUCTIONS
EN
2.2.4 End of program
The end of the program is signaled by a short beep and the message “End”
appears on the display (ref. 8 fi g. 2-03). Press any of the program buttons to
cancel “End” from the display and prepare the dishwasher for a new cycle; this
can also be done by opening and closing the door or switching the appliance
off and back on again.
2.2.5 Interrupting a program
To interrupt the current program:
press the start/pause button (ref. 5 fi g. 2-03) for a few seconds until “Time
to end” shines steady on the display (and a beep is heard). At this point the
cycle can be resumed, by pressing the start/pause button (ref. 5 fi g. 2-03),
changed or cancelled.
2.2.6 Changing the current program
To change the current program:
interrupt it (see para 2.2.5 “Interrupting a program”);
select a new program (see para 2.2.2 “Selecting a program”);
press the start/pause button (ref. 5 fi g. 2-03) to start the new program.
•
•
•
•