37
Instructions for the User
7.2 Using the thermostat-timer knob
7.2.1 Setting the time
After an interruption in the electricity supply, the display flashes at regular
intervals, showing . To set the current time, proceed as described
below.
Turn the THERMOSTAT-TIMER KNOB towards the symbol to increase
the hours at a rising speed in a repetitive cycle from 00 to 23. To increase
the hour value one hour at a time, turn the knob towards the symbol
several times in succession. Once the current hour has been set, release
the knob from the symbol. A few seconds later the current number of
hours will appear on the display in steady mode, while the minutes figures
will flash. Turn the THERMOSTAT-TIMER KNOB towards the symbol
again to increase the minutes in a repetitive cycle from 00 to 180. Once
the correct number of minutes has been set, release the knob from the
symbol. A few seconds later the current time will appear on the display in
steady mode, with the two separator dots flashing every second. You will
also note that the displays luminosity dims. To access the time setting
mode again with the oven in stand-by status, simply hold the thermostat
knob turned to the symbol for 5 seconds, until the display starts to
flash, and repeat the operations just described.
7.2.2 Setting the cooking temperature
Each of this oven's functions has a preset cooking temperature.
When the FUNCTION KNOB is turned to any function (except ) a figure
showing the temperature preset for that function appears on the display
(e.g. ). During preheating, the degrees Centigrade symbol only will
flash, while the numbers remain in steady mode. Once preheating is over,
the degrees Centigrade symbol will also switch to steady mode.
The cooking temperature can be changed at any time by turning the
THERMOSTAT-TIMER knob to the symbol or holding it in this position.
If the knob is held in position, the temperature will increase at a rising
speed in 5°C steps starting from the preset value. To reduce the cooking
temperature from the preset value, increase the value to the full scale
setting (250° or 275° depending on the chosen function), release the knob
from the symbol and turn it to the symbol again. The count will
restart from the minimum value of 50°C.
Warning: if you change function during a cooking operation, the new
temperature recommended for the new function will be displayed; it might
be different from that set for the previous function.
To Next Page
Loading...
Need help?
General
