Smeg SE332EB - Section Cut from the Countertop

INSTALLATION - 3591477A870/A
e
60 - 77 - 90 cm models:
60 - 90 cm models (limited to 3 kW)
Section cut from the countertop
Safety instructions for positioning and
installation
• Installation can be carried out on various
materials such as masonry, metal, solid
wood or plastic laminated wood as long as
they are heat resistant (>90°C).
• Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
• If the piece of furniture does not have the
required recess opening, either it will have
to be cut or masonry work carried out by a
competent technician.
• The minimum clearance between exhaust
hoods and the cooking surface must be at
least the distance indicated in the exhaust
hood installation instructions.
• The minimum clearances must also be
respected for the edges of the hob on the
back as indicated in the assembly
instructions.
• If the appliance is to be installed above an
oven, the oven must be fitted with a cooling
fan.
Appliance overall dimensions (mm)
with frame:
with bevelled edge:
with straight edge:
For this kind of hobs additional milling is needed
in the recessed hole if you wish to install the hob
flush with the work surface.
220-240 V 1N~
3 x 6 mm ²
three-core cable
220-240 V 2~
3 x 6 mm ²
three-core cable
380-415 V 2N~
4 x 4 mm ²
four-core cable
220-240 V 3~
4 x 4 mm ²
four-core cable
380-415 V 3N~
5 x 2.5 mm ²
five-core cable
Always use the jumper provided, if any,
for each connection; terminals 4 and 5
must always be connected.
220-240 V 1N~
3 x 1.5 mm ²
three-core cable
See General safety instructions.
A B C D E
min. 50 min. 460 min. 750
20
÷60
min. 50
L X Y
570 560 500
760 750 500
L X Y
300 270 490
600 565 490
770 745 490
900 850 490
L X Y G H
600 565 490 604 514
770 745 490 774 514
900 865 490 904 514