Instructions for the user
9
4. USING THE HOB
Before turning on the burners, make sure that the burners, flame-spreader
crowns and racks are fitted correctly.
In the ultra-rapid burner, the flame spreader crowns must be correctly positioned
in their seats.
4.1 Lighting the burners
The burner controlled by each knob is shown next to the knob. The
appliance is equipped with electronic ignition. Simply press the knob and
simultaneously turn it anticlockwise to the minimum flame symbol, until it lights.
On valved models, hold down the knob for about 2 seconds to keep the flame lit
and to activate the safety device. The burner may go out when the knob is
released. If this happens, repeat the procedure, holding the knob down for
longer.
(On some models only)
Double-crown burners comprise an
auxiliary and a rapid burner, controlled by
two different knobs which permit to use
both burners at the same time or to select
one or the other as required.
If the burners should go out accidentally, after about 20 seconds a safety device
will be tripped, cutting off the gas supply, even if the gas tap is open.
To Next Page
Loading...
