EasyManua.ls Logo

Smithco SweepStar 48 - End Users Service Chart

Smithco SweepStar 48
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Service
END USERS SERVICE CHART
C=Check or Clean at specified intervals
R=Replace at specified intervals
* Tire pressure: 20 psi (1.4 bar) maximum on all.
† Torque tire nuts after the first 10 hours and every 200 hours there after (64 to 74 ft/lb (87-100Nm))
§ Change Oil and Filter after first 5 hours.
¤ Clean more often under dusty conditions or when airborne debris is present , replace air cleaner parts, if very dirty.
£ Remove cooling shrouds and clean cooling areas more frequently under extremely dusty and dirty conditions.
‡ Gap .030 (.76 mm) Torque to 18-22 ft/lb (24-30 Nm)
** Replace hydraulic filter after first 20, 100, and every 250 thereafter.
The suggested maintenance checklist is not offered as a replacement for the manufacturer’s engine manual
but as a supplement. You must adhere to the guidelines established by the manufacturer for warranty cover-
age. In adverse conditions such as dirt, mud or extreme temperatures, maintenance should be more frequent.
Daily
As Required
100 Hours
200 Hours
250 Hours
300 Hours
400 Hours
Every 500 Hours/Yearly
§ Engine Oil
§ Engine Oil Filter
Engine for Leaks and Loose Parts
¤ Air Cleaner (Paper Element)
¤ Pre-Cleaner (Every 25 hours)
‡ Spark Plugs
Idle Speed
£ Air Cooling System
Belts and Hoses
* Tire Pressure
Fuel Level
Fuel Filter
Hydraulic Oil
**Hydraulic Oil Filter
Hydraulic System for Leaks and Loose Parts
Battery Electrolyte Level
Clean Battery Terminals
† Torque Lug Nuts
Lubricate
Lubricate splines on Hydrostatic Pump

Related product manuals