How to ensure safety
A
Warning!
When working near running conveyor belts or rotating rollers, do not wear loose scarves or identity
card or key lanyards put around your neck or ties, or, if so, only use those provided with a safety
breakaway buckle! Do not wear your hair hanging loose! If you are charged with loading and unload-
ing roller or modular plastic belt conveyors, wear clothes that fit tightly! 170
R
Warning!
Ensure that no person puts a hand into the inspection tunnel while the X-ray unit is activated! Switch
off the X-ray unit by means of the key switch and withdraw the key before you manually clear bag-
gage or freight items that have got stuck or before you correct other malfunctions in the inspection
tunnel or on the conveyors! If the unit does not have a key switch, wait until all indicators on the key-
board have extinguished and separate the unit from the mains by pulling the mains plug! 180
A
Warning!
Control the conveyors so that nobody risks to be injured by falling baggage or freight items and no
baggage or freight item is damaged! 200
A
Warning!
If you notice an electrical defect at the X-ray unit, e.g. through smoke or unusual heat build-up,
switch off the unit at once and disconnect it from the mains by unplugging the mains plug! If the unit
is equipped with a UPS unit (Uninterruptible Power Supply unit), switch it off as well (F 1-31 "How to
switch on") or ensure it is switched off! Make sure the unit remains turned off (e.g. by removing the
mains cable (F 1-28 "How to connect the X-ray unit to the mains") or the key) until it has been
checked by a competent service technician! 210
S
Attention!
Keep away open containers with liquids or any other non-solid materials as well as dirty or wet ob-
jects from all parts of the X-ray unit and from the feed and discharge conveyors! Closed containers
with liquids or non-solid materials as well as dirty and rain-wet baggage or freight items may only
be scanned after having been put into appropriate plastic containers (see below)! 220
95587412 01/01/09 © Smiths Heimann
I
In case of proper use, the HI-SCAN X-ray
unit is film safe, i.e. even highly sensit-
ive film material (1600 ASA) is not af-
fected after repeated exposures during
several inspection cycles. Food,
audio-/video tapes, magnetic data carri-
ers and semiconductor memories
(EPROMs) are not affected.
1-7
S
Attention!
Stop the conveyors before baggage or
freight items pile up inside the inspec-
tion tunnel or at the end of the convey-
ors! 190
To Next Page
Loading...
Need help?
General
