Smoke hollow VT280B1 - User Manual

Questions and Answers

K
Katherine HessAug 12, 2025
Why is the flame yellow or orange on my Smoke hollow VT280B1?
- K
  Karen JacksonAug 12, 2025
  If the flame on your Smoke hollow Grill is yellow or orange, it could be due to several reasons: * A new burner may have residual manufacturing oils. Burn the grill for 15 minutes on “HIGH” with the lid closed to burn them off. * Spider webs or insect nests may be in the venturi. Clean the venturi and burner assembly. * Food residue or grease may be present. Clean the burner assembly. * The valve may be poorly aligned to the burner venturi, or the air shutter on the burner may need adjustment. Ensure the burner venturi is properly engaged with the regulator stem, and loosen the screw at the burner venturi to adjust the air shutter to be between 1/8”-1/4” for proper air and gas mixture.
C
cvillaAug 22, 2025
How to fix irregular flame pattern on Smoke hollow VT280B1?
- V
  Virginia CarpenterAug 22, 2025
  An irregular flame pattern on your Smoke hollow Grill, where the flame doesn't run the full length of the burner, is likely due to clogged or blocked burner ports, or the air shutter on the burner needs adjustment. Clean the burner ports. Consult the section on “Burner Adjustment”.
A
Amanda WardNov 1, 2025
Why won't the burner light on my Smoke hollow Grill?
- M
  Michele DorseyNov 1, 2025
  If the burner on your Smoke hollow Grill won't light, there are several potential causes: * Ensure the LP cylinder regulator knob is turned to “Open” and securely attached. * Check and replace the LP cylinder if it's low or empty. * If there's a gas leak, turn the LP cylinder regulator to “OFF”, wait 5 minutes, and follow the leak testing procedure. * Make sure the coupling nut and regulator are fully connected. * Clean the burner venturi to remove any obstructions. * Reseat the burner and valve, referring to the burner assembly/maintenance instructions. * Clean the venturi and burner assembly to remove spider webs or insect nests. * Clean any clogs or blockages from the burner ports. * Replace the battery. * Clean any cooking residue from the wires or electrode with r...