SMONET Y001 - Keypad Assembly Installation

Chisel 1mm-2mm deep along the plate outline to allow the plate to
be aligned with the door frame.
C.Insert the plastic lock groove and the strike plate into door jamb
tighten with wood screws.
3)Install Keypad
< 07 >
PlaceICwire,latchlinkbaranddou-
ble-screwsthroughtheholesonthe
deadbolt,asthepictureontheright
shows.
Note:ICwireshouldbeplacedunderlatch.
Afterinstallingthefrontpad,rollthe
handlespindletotestifitcouldworkwith
deadboltornot.Ifcouldnot,takeoutthe
frontpadandrollthelatchlinkbararound
90degreeandtrytoinstallagainuntillit
couldworkwiththedeadbolt.
Pass the IC wire and the latch link bar to
mounting plate.
Use 1 flat screw to secure with the keypad
double-screw bolt.
Use 2 flat screw connect mounting plate
with latch.
Note: Please place the IC line as shown in
the figure to avoid the lock latch out of
control.
Install double-screw bolt into
keypad inner plate.