• 2 •
EEBC500B-INT-Z
INTRODUCTION
BATTERY CHARGER PLUS
Thank you for purchasing your new Snap-on Battery
Charger Plus.
The EEBC500B-INT is an advanced, full featured battery
charger with additional functions that make it a battery
service system.
The charger utilizes a microprocessor, controlling both
the voltage and current going to the battery, providing
maximum power and the precise control needed to
charge the various types of 6V (3 cell) and 12V (6 cell)
batteries on the market today, including LiFePO
4
, AGM,
Sealed Lead-Acid, Deep-Cycle, Spiral-Cell and Standard
Automotive batteries, reducing charge times while
maximizing battery life.
The EEBC500B-INT also has the ability to boost the
voltage on 24V (12 cell) batteries. (The EEBC500B-INT
does not fully charge 24V batteries).
The microprocessor is the heart of the multistage
charging algorithm built into the EEBC500B-INT.
Microprocessor-based charging technology achieves
an extremely versatile charging algorithm, and provides
a user-friendly set of controls and an easy-to-read
digital display (voltage, % of charge, alternator % of
performance). The versatility allows many different
battery types to be charged.
Flash Reprogramming Power Supply
Provides a consistent power at the OEM specied
voltage (user entered) to allow for uninterrupted ash
reprogramming of vehicle’s computers or to retain vehicle
system settings.
When reprogramming, the power supplied to the vehicle
module must not drop below OEM specied voltage.
Some reprogramming operations with the key-on will turn
on cooling fans, fuel pumps, and other components that
will cause the battery to drain faster than normal. Instead
of pulling fuses to prevent the battery drain, it is easier
and more practical to have the vehicle connected to a
constant voltage power supply. During reprogramming,
there is a risk of having the operation fail if the voltage
falls below the proper operating voltage. Sometimes a
failed operation can be recovered, but there is a chance
that failed reprogramming could ruin the control module.
Features
• 10-in. Diameter Foam-Filled Wheels –
allow easy movement around the shop and lot.
• Digital Display – % of Charge – Voltage – Alternator
Performance – shows precise data.
• Covered tool storage compartment –
convenient space for battery service tools.
• Clamp storage posts and built-in cable wraps –
keep clamps and cables organized.
• Heavy-duty clamps – provide secure connections
and minimal current losses.
• 90-in. output cables – for extended reach in vehicles
with hard-to-reach batteries.
• 9 foot AC power cord – for extended reach.
• Storage Area for Booster Packs or Auxiliary 12V
batteries in the convenient bottom tray.
To Next Page
Loading...
Need help?
General
