Snap-On CT9010 - Specifications

7
ZCT9010NA Rev. A (08/20)
100-120 Volt
Charger
Cord Length (feet)
Wire Size (AWG)
25
50
100
18
18
18
220-240 Volt
Charger
Cord Length
(meters)
Wire Size (mm)
50
75
0.75
1.0
Recommended Extension Cord Length
SAVE THESE
INSTRUCTIONS
Functional Description
F
A
B
C
D
E
Figure 1: Cordless Impact Wrench
A – Friction Ring Anvil
B – Forward/Reverse Bar
C – Trigger
D – Release Button
E – Battery Pack
F – Speed Settings
Specifications
Impact Wrench Specications
Square Drive Size
CT9010/CT9010P ........................3/8” (10mm)
CT9010QC ................................1/4” internal hex
CT9015/CT9015P ........................1/2” (13mm)
Tightening Torque*
CT9010/CT9010P ............240 ft. lbs. (325 N•m)
CT9010QC ........................115 ft. lbs. (156 N•m)
CT9015/CT9015P ............240 ft. lbs. (325 N•m)
* Torque values obtained using (7/8”) hex bolt
Bolt Breakaway Torque**
CT9010/CT9010P ............325 ft. lbs. (441 N•m)
CT9015/CT9015P ............325 ft. lbs. (441 N•m)
** Torque values obtained using (1-5/16”) hex bolt
Free Speed ............................................ 1760 rpm
Impacts per Minute ................................3520 ipm
Motor Voltage ........................................18.0 VDC
Weight with Battery Pack (Lithium-Ion)
CT9010/CT9010P .....................4.9 lbs. (2.2 kg)
CT9010QC .................................4.9 lbs. (2.2 kg)
CT9015/CT9015P .....................4.9 lbs. (2.2 kg)
Noise* (Tested in accordance with EN 60745)
Sound Pressure Level (A) .......................97.0 dB
Uncertainty, K ...........................................3.0 dB
Sound Power Level (A) .........................108.0 dB
Uncertainty, K ...........................................3.0 dB
Vibration* (Tested in accordance with EN 60745)
Vibration Level .....................................8.64 m/s
2
Uncertainty, K ......................................1.50 m/s
2
*These declared values were obtained by
laboratory type testing with the stated standards
and are not adequate for use in risk assessments.
Values measured in individual work places may be
higher. Values and risk of harm experienced by an
individual user are unique and depend upon the
environment and manner in which the user works,
the work piece and the workstation design, as well
as upon the exposure time and the physical
condition of the user.
Snap-on disclaims liability for the consequences of
using the declared values, instead of values
reflecting the actual exposure determined in an
individual risk assessment in a work place situation
over which we have no control.
Symbology
SYMBOLOGY
REFER TO INSTRUCTION
MANUAL/BOOKLET
WEAR EYE PROTECTION
WEAR HEARING PROTECTION
VIBRATION HAZARD
VOLTS