Snap-On CT9080 - Battery Charger Specifications; Battery Pack Specifications; Operation

8
ZCT9080CE Rev. A (04/21)
DOUBLE INSULATION
BACK FEED PROTECTION
PROPERLY RECYCLE BATTERY
DO NOT THROW IN GARBAGE
BC
CALIFORNIA -
TITLE 20 COMPLIANT
UKCA (UK CONFORMITY
ASSESSED) MARKING
Battery Pack Specifications
CTB185 CTB8187
Type Lithium-Ion Lithium-Ion
Voltage 18 VDC
(3.6 V x 5 cell
pairs)
18 VDC
(3.6 V x 5 cell
pairs)
Weight ~1.5 lbs
(0.68 kg)
~1.5 lbs
(0.68 kg)
Charge Time refer to section Battery Charging
Life
1000 cycles
(1 cycle=1 charge and 1 discharge)
Capacity 5.0 Ah 5.0 Ah
Discharge
Temperature
Range
-4°F(-20°C) to 140°F(60°C)
Battery Charger
Specifications
CTC131/CTCA131/
CTCEU131/CTCJ131
Input 100-240V, 50/60 Hz
Output 5.0 A
Output
USB Power Port
5.0VDC@0.5A
Weight ~2.11 lbs (0.95 kg)
Charging
Temperature
Range
32°F(0°C) to 113°F(45°C)
Operation
The Snap-on Cordless Impact Wrench is ideal for a wide
variety of fastener turning jobs in both the industrial and
automotive fields. When used with Snap-on impact
sockets, it provides power and speed for greater job
efficiency with less operator fatigue. The impact wrench
also adds the freedom of movement not usually available
with products requiring air hoses or electrical cords.
Application
Friction Ring Anvil
1. When installing an impact socket, place the forward/
reverse bar in the center position to avoid accidental
starting of the tool; or remove the battery pack.
2. Align the square of the socket with four flats at the
end of the anvil.
3. Push the socket over the friction ring, until it comes
to a stop.
4. To remove the impact socket, grip the socket firmly
and slip off the anvil.
This type of anvil is suitable for exchanging sockets regularly,
like in a garage environment.
Pinned Anvil
1. When installing an impact socket, place the forward/
reverse bar in the center position to avoid accidental
starting of the tool; or remove the battery pack.
2. Align the hole on the socket with the pin on the anvil.
3. Align the squares together and push socket onto the
anvil until the pin is in the hole of the socket.
4. To remove the impact socket, use a pointed object to
depress the pin through the hole. Then slide off the
impact socket.
This type of anvil is suitable for industrial usage, such as an
assembly line.